- Top Tuotteet
- asiakkaiden arvostelut
-
ZETA Revolver Vaihtovipu
Works as should! It's held up so far prefer oem but this makes a great spare to have its come in handy more than once.It's noticeably nicer to use than the stock lever.They're super nice, inexpen...
Lue lisää -
ZETA Heel Guard
It is a SIDE only Guard, so if you take it to a Dealer, you will be instructed. However, it looks the coolest.
Lue lisää
It can be installed on the MD44 with no problem, but it is difficult to install o... -
ZETA Heel Guard
It is only 5 minutes work to remove and replace 3 screws of OEMGuard. If you take it out of the package and look at it well, there are not a few small scratches. If you install it, you will not k...
Lue lisää -
ZETA Stabilisaattori COMP
I'm embarrassed to say that I first learned about this item at my local RecycleMotorcyclePartsShop just a few days ago.
Lue lisää
It is the type that adjusts the position with the old type Edge that is ... -
ZETA Akselimutteri
It is a little expensive, but if you change the Rear Axle Nut to this one, it will be a good accent. I also changed the exterior bolt and brake hose guide to ZETA RedPlating parts, so the RedPlat...
Lue lisää -
ZETA Vihje Revolver Vaihtovipuun
I bought an additional one for consumables.
Lue lisää
The price and quality are fair. -
ZETA Vihje Revolver Vaihtovipuun
ZETA's RevolverShift is a great product that allows you to fine-tune the tip in 6 steps of 5 degrees, but if you change the position too often, the bolt will break. So, if you have a lot of Boots...
Lue lisää -
ZETA Vihje Revolver Vaihtovipuun
The one used for WR250X was coated with Locktite, so the Bolt broke when loosening it, so the same one for WR250R has a loosening washer in between!
Lue lisää -
ZETA Vihje Revolver Vaihtovipuun
This is completely a defect of Bolt's strength calculation, there is a description to apply Locktite, but when I loosened Tip's Bolt to do setting while touring for the first time in a month sinc...
Lue lisää -
ZETA Stabilisaattori COMP
What made you decide to buy?
Lue lisää
I was concerned about the fading of the top side of the OEM Handlebar Clamp
Was it difficult to install? What is the point or hang of the installation?
J...
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING