- I owned an SR400 and the carb fit so tightly inside the frame so I cannot adjust the idle screw. Thankfully I've found this product for my carb and even my bike.Lue lisää
- FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- KAWASAKI Z1300/KZ1300
Another great product from Bito JB power. Best customer service in the industry. Quality was top of the line and they operate flawlessly. Deeply impressed. Lue lisää - sopii:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z2 (750RS/Z750FOUR)
fast postage.great looking carbs.made the bike run great right out of the box.this is the way to go beats messing around with old carbsLue lisää - FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- SUZUKI BANDIT400
Loving these 33mm FCR carbs! Bike is a 1992 GSF 400 with .04 over Suzki pistons and gk73 GSXR 400 camshafts.
Tune: 125 Main Fuel Jet, 200 Main Air Jet, 42 Slow Jet, 2 1/2 turns out on fuel screw, 3/4...Lue lisää - sopii:
- KAWASAKI Z1 (900SUPER4)
- KAWASAKI Z2 (750RS/Z750FOUR)
The engine starts better and the acceleration performance is stronger without the mid-rotation stutter at the beginning of running. However, the fuel is still too rich and there is a lot of black smok...Lue lisää - The length is that of the FCR Carburetor BodyOEM; note that there is a difference in this stop screw length between the Large Type carburetor and the Small Type carburetor.Simply fix the bracket to th...Lue lisää
- FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- KAWASAKI GPZ900R 84-03 (A1-A16)
OEMCVK #4Slide valve is worn out and sucks secondary air, so negative pressure is not stable. FCR was the only choice.Disassembled for inspection of each part and sprayed with Bell Hammer for bearing....Lue lisää - This Thruttle Stop screw is exactly the same length as the FCROEM. However, for installation in the Float chamber fixed Bolt section of #1Carburetor Bracket." is attached to the product. This Bracket ...Lue lisää
- FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- HONDA RVF400 (NC35)
- HONDA VFR400R (NC30)
The racing cabs are very easy to set up, and once you get the settings right, you will be amazed at the acceleration power you can get. However, setting is very difficult. It is very difficult to set ...Lue lisää - FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- YAMAHA XJR1200
- YAMAHA XJR1300
I can do the tuning myself if I try hard enough.It will take time and Jet supplies.I had it tuned by a PRO.Power is a lush.Lue lisää - FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- KAWASAKI ZRX1200R
I submitted a Setting in FunnelSpec.I had a one-off muffler in the car, so the basic setting did not match the fuel mixture.The fuel mixture was matched while changing the Jet.It is troublesome to rem...Lue lisää - FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- HONDA CBR250RR (MC22) 90-91
The one for MC22 was used on MC19.The OEM Throttle Wire was too long and did not fit, so I installed it without the return wire. (To be adjusted later by JB in the posterior Thailandco.)And the OEM wi...Lue lisää - I needed this adapter to attach the power filter to the FCR carburetor body and to prevent the carburetor body from leaking air. One of the adapters I had in storage was crushed into a flat piece, so ...Lue lisää
- FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- KAWASAKI ZXR750
안녕하세요
좋은제품 찾던중 위바이크를 알게돼서
레어한 카브레더를 발견해 구입까지 하게돼었습니다
진심 fcr카브레더는 최고중에 최고입니다
앞으로 위바이크에서 좋은가격에 좋은 제품 또다시 구입하지 싶습니다
항상 지금과 같은 위바이크 돼시고. 더욱 발전하는 위바이크가 돼길 바랍니다...Lue lisää - CRS Carburetormennessä JB POWER (BITO R&D)sopii:
- HONDA CBX1000
The appearance is very good. They are factory cheched, unscratched and assembled straight and with an attention to details that shows a professional manner. The idle setting adjuster seen in Webike pi...Lue lisää - FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- KAWASAKI ZEPHYR750
I had a hard time with Setting. I heard that I could run the car on a pontoon, but the jetting was so thick that it didn't blow up at all, and it took me a while to get it running properly.I think it ...Lue lisää - Idling AdjusterIt's easy.Lue lisää
- sopii:
- HONDA CB750F 79-84
- HONDA CB750 Four(CB750K) 79-80 (DOHC)
I went with CR because of the malfunctioning Normal cab.It was easy to replace and Idling normally in about Cell3 times.Afterwards, I only did Setting of the upper part, but it was a good feeling to t...Lue lisää - With this Parts, Remote is done by Left hand, but tightening and loosening may be lost by Left hand. It is not a problem if you get used to it. Also, it is thought that a few millimeters long Screw is...Lue lisää
- FCR Carburetormennessä JB POWER (BITO R&D)sopii:
- SUZUKI BANDIT400
Great carbs for the Bandit 400! Please note; the OEM throttle assembly will not work and the OEM fuel valve will have difficulty delivering enough fuel. I suggest a qualified tuner set them up or ask ...Lue lisää
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING