- Lisätarvikkeet
- sähkö-
- Kierrosajastin
- CLEVER LIGHT
- CLEVER LIGHT - Kierrosajastin
- Tuotelista
- ZiiX kierrosajastin
ZiiX kierrosajastin
Tuote # W-1369-P30251162
90.32 EUR (14,720 JPY)
Listahinta: 90.32 EUR Tallentaa 0%
+147 Webike kohta (0.9 EUR)
Tuote # W-1369-P30251162
90.32 EUR (14,720 JPY)
Listahinta: 90.32 EUR Tallentaa 0%
+147 Webike kohta (0.9 EUR)
4.3 / 5
18 arvostelut
When I went to run Circuit a few times, I became curious about how many seconds I was running and bought one.
The installation is easy if you are familiar with the electrical system.
The only thing that bothers me is the location of the Sensor.
Depending on the Motorcycle, it is very difficult to decide where to put the Sensor.
In the Racer's Under Cowl, the Sensor is deformed by the heat of the Exhaust System, so a little ingenuity is required.
It is very useful because it is easy to know the time.View Detail
I bought it to measure Time at a driving session.
I used it in Tsukuba and Mogi, and it worked fine.
The installation is bracketed to Under Cowl.
It's easy to install, so if you want to measure Time for now, this is a good introduction.
I haven't compared it to the others, so I don't really know, but it feels like the battery drains faster.View Detail
Motive for purchasing
I bought it to check the time while driving in the Circuit At first, it was good enough for me to know the time, so I used Cue Stars and Dig High technologyLap timers of GPType S, such as spice, have a high The cheapest magnetic type is the LeverLight Lap I decided to try the timer
About the product
The numbers are large and the visibility is good
The information displayed is only the time of the lap, so you can't compare it with other laps while driving Even so, the numbers are still large enough to be visible while driving I think that this is an excellent costumer for those who only need to know the lap time anyway
Connect to the Battery and you don't need batteries
Lap timerBody starts with the Button battery, but it connects to the attached Battery You can use the Wiring function without the Button battery There is a switch to turn on/off the power, but be careful not to leave it on and leave the battery on Let's
Limited to Circuit with embedded porcelain bars
The included magnetic sensor detects and wraps the magnetic bars embedded in the Circuit Unlike GPS, the accuracy is measured by magnetic transit timing, so the accuracy is relatively high (Depending on the position of the Sensor, it may pick up Noise.) But, on the other hand, you can't measure a lap without a porcelain bar, so I'm going to have to get the Circuit running well before I buy it You need to make sure that the porcelain bars are embedded
It's a bit of a hassle to install
The key is the magnetic sensor, but if you are not careful about the position of the magnetic sensor, it will not detect magnetism and will not be able to correctly wrap the lap It cannot be measured Also [Contents] does not even come with a bracket to attach the Sensor to the vehicle by yourself You need to prepare a Bracket to match, and the Lap timerBody is also fine Large size, Quantity:I'm also very careful about the position to setView Detail
What made you decide to buy?
I rejected the GPS-based QSTARZ and Dig spice because they are too expensive at $60,000-$40,000
The frequently driven Circuit is compatible with magnetic sensors, and it was affordable Choice
How was your experience with it?
The results of using it at three locations in the manual's "Magnetic Bar Buried Circuit List"of the instructions
Okegawa Sports Land…15cm of ground clearance is OK
However, the magnetic bar does not pass through 50 to 60cm from the end of the courseLeft, so it will not react Mm (A magnetic bar is buried a few meters from the ControlLine.)
Quick hanyu & hellip;12cm of ground clearance is not enough
They were buried a long time ago and they hardly responded
If you set up the SS at 9 cm above ground level, 80% of the time it responds, but there are many malfunctions
Tsukuba 1000…ground clearance of 18cm is OK
Only one lap of the 45 minutes was unresponsive
Was it difficult to install? (In the case of hard parts)
Be careful with the handling and fixing of Wiring to avoid the high temperature of the Exhaust pipe etc I did
Now you need some DIY skills on the Sensor side Bracket
What is the point or hang of installation (for hard parts)?
It's difficult to connect the power supply to ACC, so it's connected directly to the Battery
(After all, it's non-Waterproof, and it's removed except when running Circuit, so Large It's tough:)
The magnetic sensor is installed on the center line of the straight line with a ground clearance of about 10 cm or less in the Rider's riding condition Then it's best
How does it feel when you wear it and what is your height, weight, etc. (in the case of Apparel)? Any
[Was there anything that disappointed you?
The connector is thin and not very durable
Do you have any wishes or improvements you would like to make for the Manufacturer?
Waterproof Specification of the body
Strengthened connector part
[Do you have any products to compare it to?
The company's TimeA Tucker
[Others]
The magnetic sensor bracket is not included, so this is a DIY project
It's even better if you can use the butterfly screw to adjust the ground clearance
The magnetic sensor is covered with a plastic bag to prevent wounds and stains WaterproofView Detail
Purchase required for traveling Circuit. I am satisfied with the function I was looking for! I would like to improve about the point that there is no Waterproof function to Body although it has the Waterproof function of Sensor part!View Detail
To continue viewing this product on Japan domestic webike (in Japanese), press "Go to Japan Domestic".
Ilmoitus
Valitse vaihtoehto ennen lisätä koriin.
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING
* The BEST and MUST store to find Japanese parts.
* Register now for amazing deals and other special offers!
* Over 800,000 listed items. It's hard NOT to find your parts.
Congratulations! Your new account has been successfully created! You can now take advantage of member privileges to enhance your online
shopping experience with us. If you have ANY questions about the
operation of this online shop, please email Webike through CONTACT US.
A confirmation has been sent to the provided email address. If you
have not received it within the hour, please contact us.