[Tekniset]
Nimellisjännite : DC12V
Ulompi koko : W25.5mm x H30.5mm x D15.5mm (* Ilman protrusioita)
[Tuotteen sisältö]
Body x1pc.
Kaksipuoleinen nauha x2kpl. (1mm paksu / 2mm paksu 1kpl / kapea) (* Käytä 1 arkki väliaikaisena kiinnityksenä asetusten aikana.)
Käyttöohje / takuukortti
* Asennettaessa yleiskäyttöön tarkoitettu tuote, PG-110 tai PG-220 myydään erikseen vaaditaan asennettujen ajoneuvojen mukaan.
Huomaa, että emme ota mitään vastuuta mistään vahingoista, kuten tämän tuotteen käytön seurauksena tapahtuneesta vikaantumisesta tai onnettomuudesta.
[Specification]
・Rated voltage: DC12V
・Outer diameter dimension: W25.5mm x H30.5mm x D15.5mm (*excluding protruding parts)
[Components]
・Main unit x 1
・Double-sided tape x 2 (1mm thick, 2mm thick, 1 each) (*Use 1 tape for temporary fixing during setting.)
・Instruction manual
*This product is for 12V motorcycles (battery-powered vehicles) only.
*This product cannot be installed on vehicles with point ignition type.The high voltage generated when the key is turned from ON to OFF may short-circuit the SPI unit and cause a failure.(Ex) HONDA CB400FOUR
In the case of HONDA CB400FOUR, there is a case that SPI was short-circuited because 65V (+20V, -45V) were generated at the moment when the key was turned from ON to OFF.
*This product is only for motorcycles with electric speedometers.When installing on a mechanical speedometer (meter cable type), please purchase the optional pulse generator PG-110.
*When the clutch is depressed while driving, the display shows a gear other than the one in which the clutch is engaged, but this is not a malfunction.
*Prioritize safety while driving and do not be careless in front.
*Please do not use non-resistive spark plugs.If you use a plug without resistance, noise may be generated and the rotation signal may not be input correctly, so please use a spark plug with resistance.
*Please put the attached double-sided tape on the back side of this product to prevent water from entering because there is a switch.
*Install the product correctly according to the instruction manual.Improper installation may result in fire or equipment damage.
*After installing this product, periodically inspect it to see if any parts have fallen off.
*PROTEC is not responsible for any damage or accident caused by the use of this product.
*Protec is not responsible for any labor charges for removal or other expenses incurred during repair.
*All vehicles that have been tested by Protec are stock.There is a possibility that a problem may occur if the vehicle is equipped with aftermarket parts other than stock parts.
*This product can be used for vehicles that are not listed in the compatibility information below.Please refer to the list for the required parts.
*Please refer to the service manual of your motorcycle to confirm the respective wiring before installation.
*Some Harley-Davidson [TC96 '05] injection models do not work with SPI.If you are planning to install the product, please contact PROTEC before purchase.
*For other Harley-Davidson models, it can be installed on with the SPI-110 and optional PG-110 + PG-220.