| |
| | | | | | | | |
| Insert the key into the key cylinder. Insert the key into the key cylinder. | | Turn the key to the right (3 o'clock). | | Push the red oval button at the top of the key cylinder. | | The flap that says "PRESS" will float. | |
| |
| | | | | | |
| Please make sure that the key is inserted and turned to the right (3 o'clock). | | With the key turned to the right (3 o'clock), press down on the upper side (marked with *) of the triangle marked "PRESS". Please lock it. | | When the lid is locked, turn the key to the left (12 o'clock) to lock the buttons.When the key can be removed and all buttons are locked, the lid cannot be opened or closed.After this, be sure to lift the lid slightly to make sure that it is securely locked. | |
| |
| If the red button on the key cylinder cannot be unlocked (the flap does not open), the red button is retracted (the flap is half-locked).In this case, please follow the steps below to deactivate it. | | | | | |
|
| How to unlock the flap half-lock state | |
|
| | | | | | | | The lid is not locked when the flap is half locked.There is resistance, but pull hard to open the lid. | | Remove the lid to reveal the locking flap. | | Tilt that flap back. | | The flap returns to position and the flap half-lock state can be released. | |
| |
| With the top lid open, align the case with the base, lift the base with your left hand and press down on the bottom of the case from above with your right hand to lock it in place. In particular, for small vehicles, the rear suspension may be soft and it may be difficult to lock it securely just by pressing from the top, so be sure to install it in this way. | | | | |
|
| How to unlock the lock state to the base | |
|
| After locking the case to the base, be sure to pull the case upward to confirm the locked state.As a method of confirmation, hold down the case removal button on the lower side of the key cylinder, and if the position of the button is retracted approx. 6 mm further than stock (base half-locked state) as shown in the figure, the case is not correctly locked to the base.To remove the case, press the case removal button again, remove the case from the base, and reattach it securely. | | | | | | | When the button is pressed, it retracts about 6mm from the stock locking state. | |