- I always use them because they are cheaper than OEM and the quality is good.However, only the NORMAL length is sold, so it may not be possible to install if an Up Handle etc. is attached.Lue lisää
- Отличныйй троссик газа, недорогая замена старому оригинальному троссу. Всё подошло отлично.Рекомендую к покупку.
----------------------------------------------------------
An excellent truss of ...Lue lisää - The Accelerator Wire on my gsx400Impulse GK79A got stuck and stopped working, so I replaced it myself. Even such a simple repair would have cost a lot of money if I had asked a store to do it. It was ...Lue lisää
- [How is it used?I purchased this product because the original installation had fluffed up.OEM Product was discontinued.I bought it with Pull Side.Was the one you received as per Image?No difference fr...Lue lisää
- [How is it used?I purchased this product because the original installation had fluffed up.OEM Product was discontinued.Was the one you received as per Image?No difference from OEM Product.How was your...Lue lisää
- This is an impression of using it on a C-type ZZr1100. It seems to be usable without any problem since it is common with D type.We bought a ZZr that had been laid up for a long time, and when we raise...Lue lisää
- To replace the carburetor, we had to remove the carburetor box and shift the carburetor slightly, which would have been much easier;I think it's the strongest in terms of quality and costa…Lue lisää
- While OEM parts are reliable, many of them are quite expensive, but NTB's products are reliable because of their reasonable prices and high quality.It is expected that OEM parts for old cars will be d...Lue lisää
- The Reverse Side ran out, so I bought both the pull and the return.My CB400SF Ver.S '97 is out of conformity, but I bought it because it is CB of the same age.It was necessary to remove the Carburetor...Lue lisää
- It's hard to have overall satisfaction when you expect something normal and get a normal result.[How is it used?When I disassembled the VTR250 and reassembled it again, the cable that was attached to ...Lue lisää
- [How is it used?When I disassembled the VTR250 and reassembled it again, the cable that was attached to it was broken, so I decided to change it.Was the one you received as per Image?It's an OEM look ...Lue lisää
- I changed the Throttle Wire while I removed the Tank to check the Plug without the Engine.NTB's products are as good as the OEM products, so you can use them without worry. The durability is the same ...Lue lisää
- This time I bought it to remove the Reverse Side and make one pull on the Pull Side onlyIt should be noted that it is only the Pull Side of the Throttle Wire Side is not included Maybe there is no con...Lue lisää
- This is a replacement from the original, and probably new car-installed product that came with itThe Wire movement itself didn't feel bad, but the RubberBoots are starting to crack Therefore, I decide...Lue lisää
- It's been 2 years since the replacement and there are no problemsI think this is a quality product that is safe to useOEM Products are no longer availableThank you, NTB(I also use Clutch Cable and Bra...Lue lisää
- I installed it in DRAGSTAR 250 VG 02 J.Does Slot get lighter?I bought a bar TEC 's Throttle wire in the Amazon, but the Screw on the return side wire is too big to enter and the pull side is thin ...Lue lisää
THE LARGEST
SHOP IN JAPAN
EXCLUSIVE COUPONS,
SALE, DEALS
FAST, RELIABLE
SHIPPING